Some tips to achieve a 'good installation':

1. Keep the system out of direct midday sun.

2 Allow 1 meter clearance on the left side - for removing the lamp & sleeve.

3. Try to run your inlet and outlet horizontal then vertical up to your system. This provides some flexibility for connecting and disconnecting the piping. Its very hard getting things right if the piping comes straight up out of the ground into the system.

4. Don't put the system above the 240 v 3 pin plug. Water splashes occur every time you service the system.

5. If possible do try to locate the system under a rain shelter. Its nicer for the serviceman! The systems cover is waterproof, but just like your car, its best kept out of the rain.